Sole-Mate Anti-Static Footwear Testing Station

Exloc Instruments: your one-stop-shop for instruments and electrical equipment for use in hazardous classified locations.
Saving you time & money solving challenging problems!

Anti-Static Footwear Testing Station

Sole-Mate TESTING STATION

Simple to install and operate
Calibrated to ANSI Z41 SD Type II
LED indication & audible alarm
Battery operated
Stainless steel sole plate
Comes with instruction board
Also suitable for static dissipative gloves

Designed to check the condition of static-dissipative footwear, the Sole-Mate is a simple to use device for all personnel entering hazardous (classified) locations. It tests continuity from the operator's finger to the floor plate – right through the static-dissipative footwear.

Installed at an entry point outside of the hazardous area, the system will provide a "pass" or "fail" signal dependent upon whether or not the measured resistance falls within the pre-set limits. Units for the U.S. market are calibrated to the ANSI Z41 SD Type II standard, but alternative measurement ranges are available to meet custom or other national standards.

The Sole-Mate system is self contained and battery powered for simple installation. Low battery warning is a standard feature, and a calibration test unit is available for periodic testing. Instruction boards are available in alternative languages.

Specifications

Calibration	ANSI Z41 SD Type II (lower limit 1x10⁶ ohm, upper limit 1x10⁹ ohm). Other calibration ranges available to special order.
Indication and Alarms	Bright LED indication of "pass", "too low", "too high", "battery low". Shrill audible alarm for "fail".
Actuation	Operator places both feet on sole plate and touches finger pad for resistive test to take place.
*Options:*	Instruction boards in Spanish, German, French, Italian, Portugese. Other languages to special order.

This page last updated 6/3/08

legal notice • site map